LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> RX 350 AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control System >> SFI System >> DTC P0300 Random / Multiple Cylinder Misfire Detected; DTC P0301 Cylinder 1 Misfire Detected; DTC P0302 Cylinder 2 Misfire Detected; DTC P0303 Cylinder 3 Misfire Detected; DTC P0304 Cylinder 4 Misfire Detected; DTC P0305 Cylinder 5 Misfire Detected; DTC P0306 Cylinder 6 Misfire Detected >> Confirmation Driving Pattern

Confirmation Driving Pattern

  1. Connect the intelligent tester to the DLC3.
  2. Turn the ignition switch to the ON position.
  3. Turn the tester on.
  4. Record the DTC(s) and freeze frame data.
  5. Using the tester, select the check mode (See CHECK MODE PROCEDURE  ).
  6. Read the misfire counts of each cylinder (CYL #1 to #6) with the engine in an idling condition. If any misfire count is displayed, skip the following confirmation driving pattern.
  7. Drive the vehicle several times with the MISFIRE RPM and MISFIRE LOAD in the DATA LIST.

    HINT:

    In order to store misfire DTCs, it is necessary to drive the vehicle for the period of time shown in the table below, with the MISFIRE RPM and MISFIRE LOAD in the DATA LIST.

    DATA LIST CHART

    Engine RPM Duration
    Idling 3.5 minutes or more
    1,000 3 minutes or more
    2,000 1.5 minutes or more
    3,000 1 minute or more
  8. Check whether misfires have occurred by checking DTCs and freeze frame data.

    HINT:

    Do not turn the ignition switch off until the stored DTC(s) and freeze frame data have been recorded. When the ECM returns to normal mode (default), the stored DTC(s), freeze frame data and other data will be erased.

  9. Record the DTC(s), freeze frame data and misfire counts.
  10. Turn the ignition switch off and wait for at least 5 seconds.
scientia non olet · About LEMON Manuals