Typical Malfunction Thresholds
TYPICAL MALFUNCTION THRESHOLDS
| One of the following conditions is met | - |
| A. All of the following conditions are met | - |
| a. Battery voltage | 11 V or more, and less than 13 V |
| b. Target duty ratio | Less than 70% |
| c. Output signal duty ratio | 100% or more |
| B. All of the following conditions are met | - |
| a. Battery voltage | 13 V or more |
| b. Target duty ratio | Less than 80% |
| c. Output signal duty ratio | 100% or more |
| C. Both of the following conditions are met | - |
| a. Current cut status | Not cut |
| b. Output signal duty ratio | 3% or less |