SEAT VIBRATOR MODULE ASSEMBLY (for Ottoman): Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL SEAT VIBRATOR MODULE ASSEMBLY 
   1. Attach the claw and install the module with the 2 bolts.
      Fig 1: Identifying Seat Vibrator Module Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the connector.
   3. Connect the air hose connector.
      Fig 2: Identifying Air Hose Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See INSTALLATION )
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH  (See INSTALLATION )
4. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
5. INSTALL LUGGAGE COMPARTMENT TRIM COVER SUB-ASSEMBLY FRONT  (See INSTALLATION )
6. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler)  (See INSTALLATION )
7. INSTALL NO. 2 LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (w/o Rear Cooler)  (See INSTALLATION )
8. INSTALL LUGGAGE COMPARTMENT LIGHT ASSEMBLY  (See INSTALLATION )
9. INSTALL DECK TRIM SIDE BOARD LH  (See INSTALLATION )
10. INSTALL DECK TRIM SIDE BOARD RH  (See INSTALLATION )
11. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
12. INSTALL ROPE HOOK  (See INSTALLATION )
13. INSTALL LUGGAGE COMPARTMENT FLOOR MAT SUB-ASSEMBLY  (See INSTALLATION )
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
15. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
16. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
17. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).