Lumbar Support Adjuster Assembly: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedure listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH 
   1. Install the lumbar support adjuster and attach the 4 clamps.
   2. for Driver Side:
      1. Install the 2 motors with the 4 bolts.
      2. Connect the 2 connectors.
      Fig 1: Identifying Lumbar Support Adjuster Motor Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. for Passenger Side:
      1. Install the motor with the 2 bolts.
      2. Connect the connector.
2. INSTALL SEAT CLIMATE CONTROL CONTROLLER LH (BACK SIDE) (w/ Climate Control Seat System) 
   1. Install the climate control controller with the 2 screws.
      Fig 2: Locating Climate Control Controller Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL SEATBACK COVER WITH PAD 
   1. Install the seatback cover (with pad) to the seatback frame and attach the hooks and install the 2 clips.
      Fig 3: Identifying Seatback Cover (With Pads) Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. w/ Climate Control Seat System:

      Connect the connector.

      Fig 4: Identifying Seatback Cover Connector W/Climate Control Seat System

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. for Front Passenger Side:
      1. Install the power seat switch and attach the 2 claws.
      2. Connect the connector.
         Fig 5: Identifying Power Seat Switch Claws

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Install the seatback cover bracket with the bolt.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

      Fig 6: Identifying Seatback Cover Bracket Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL FRONT SEAT HEADREST SUPPORT (See  REASSEMBLY  ) 
5. INSTALL FRONT SEAT HEADREST ASSEMBLY (See  REASSEMBLY  ) 
6. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH (See  REASSEMBLY  ) 
7. INSTALL FRONT SEAT CUSHION SHIELD INNER LH (See  REASSEMBLY  ) 
8. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH  (See INSTALLATION )
9. INSTALL FRONT SEAT CUSHION SHIELD LH (See  REASSEMBLY  ) 
10. INSTALL FRONT SEAT ASSEMBLY LH 
    1. Install the front seat assembly (see REASSEMBLY ).