LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Spiral Cable >> Removal

Spiral Cable: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: Wait for 90 seconds after disconnecting cable to prevent the airbag deployment.
  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  3. REMOVE LOWER NO. 3 STEERING WHEEL COVER (See  REMOVAL   ) 
  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER (See  REMOVAL   ) 
  5. REMOVE STEERING PAD (See  REMOVAL   ) 
  6. REMOVE STEERING WHEEL ASSEMBLY 

    For Manual Tilt (See REMOVAL )

    For Power Tilt and Power Telescopic (See REMOVAL )

  7. REMOVE STEERING COLUMN COVER 

    For Manual Tilt (See REMOVAL )

    For Power Tilt and Power Telescopic (See REMOVAL )

  8. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR 
    1. Disconnect the connectors from the spiral cable with steering sensor.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
    2. Disengage the 3 claws and remove the spiral cable with steering sensor.
      Fig 1: Identifying Claws On Spiral Cable
      G05319934Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. SEPARATE SPIRAL CABLE 
    1. Disengage the 6 claws and separate the spiral cable.
scientia non olet · About LEMON Manuals