LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Driver Side Knee Airbag Assembly >> Removal

Driver Side Knee Airbag Assembly: Removal

  1. PRECAUTION 
    CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
    Fig 1: Identifying Driver Side Knee Airbag Assembly (Vehicle Involved In Collision And Airbag Not Deployed)
    G05319943Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT DOOR SCUFF PLATE (w/o Illumination) (See  REMOVAL  ) 
  4. REMOVE FRONT DOOR SCUFF PLATE (w/ Illumination) (See  REMOVAL  ) 
  5. REMOVE FRONT DOOR OPENING TRIM COVER (See  REMOVAL  ) 
  6. REMOVE INSTRUMENT SIDE PANEL (See  REMOVAL  ) 
  7. REMOVE NO.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (See  REMOVAL  ) 
  9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY 
    1. Remove the 4 bolts and driver side knee airbag assembly.
    2. Disconnect the connector.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
      Fig 2: Identifying Driver Side Knee Airbag Assembly Bolts
      G05319944Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals