FRONT PROPELLER SHAFT ASSEMBLY (for 4WD): Installation

1. Align the matchmarks on the transfer companion flange and the front propeller shaft.
2. Temporarily tighten the front propeller shaft with the 6 bolts and 2 universal joint washers.

   HINT:

   If reusing the bolts, apply engine oil to the bolts before use.

3. Align the matchmarks on the differential companion flange and the front propeller shaft.
   Fig 1: Identifying Front Propeller Shaft Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Temporarily tighten the front propeller shaft with the 6 bolts and 2 universal joint washers.

   HINT:

   If reusing the bolts, apply engine oil to the bolts before use.

   Fig 2: Identifying Front Propeller Shaft Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using a screwdriver or equivalent, hold the transfer companion flange.
6. Using a socket hexagon wrench 6 mm, fully tighten the front propeller shaft with the 6 bolts.

   Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf) 

   NOTE: Be careful not to damage the front propeller shaft.
   Fig 3: Tightening Front Propeller Shaft Bolts Using Wrench

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Using a screwdriver or equivalent, hold the transfer companion flange.
8. Using a socket hexagon wrench 6 mm, fully tighten the front propeller shaft with the 6 bolts.

   Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf) 

   NOTE: Be careful not to damage the front propeller shaft.

(See INSTALLATION (For 4G-FSE) )