LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GX 470 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Steering Pad >> Installation

Steering Pad: Installation

  1. INSTALL STEERING PAD 
    1. Support the steering pad with one hand.
      Fig 1: Installing Steering Pad
      G04969056Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 2 connectors to the steering pad.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
    3. Connect the horn connector.
    4. Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
    5. Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.

      Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf) 

  2. INSTALL STEERING WHEEL COVER LOWER NO. 3 
    1. Install the steering wheel No.3 cover lower.
  3. INSTALL STEERING WHEEL COVER LOWER NO. 2 
    1. Install the steering wheel No.2 cover lower.
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    5. Fig 2: Identifying Steering Pad
    G05265496Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSPECT STEERING PAD 
    1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

      Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

    2. Make sure that the horn sounds.

      HINT:

      If the horn does not sound, inspect the horn system (See PROBLEM SYMPTOMS TABLE ).

  6. INSPECT SRS WARNING LIGHT 
    1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM  ).
scientia non olet · About LEMON Manuals