Monitor Result
Refer to CHECKING MONITOR STATUS .
The test value and test limit information are described as shown in the following table. Check the monitor result and test values after performing the monitor drive pattern (refer to "Confirmation Monitor".)
- MID (Monitor Identification Data) is assigned to each emissions-related component.
- TID (Test Identification Data) is assigned to each test value.
- Scaling is used to calculate the test value indicated on generic OBD II scan tools.
Secondary air injection (AIR) system
TEST VALUE AND TEST LIMIT INFORMATION
| MID | TID | Scaling | Description of Test Value | Minimum Test Limit | Maximum Test Limit |
|---|---|---|---|---|---|
| $71 | $E1 | Multiply by 0.01 (g/s) | Test value of AIR amount insufficient | Minimum test limit | Maximum test limit |
| $71 | $E2 | Multiply by 0.01 (kPa) | Test value of AIR pump stuck ON | Minimum test limit | Maximum test limit |
| $71 | $E3 | Multiply by 0.01 (kPa) | Test value of AIR pump stuck OFF | Minimum test limit | Maximum test limit |
| $71 | $E4 | Multiply by 0.01 (kPa) | Test value of AIR control valve ON | Minimum test limit | Maximum test limit |
| $71 | $E5 | Multiply by 0.01 (kPa) | Test value of AIR control valve OFF | Minimum test limit | Maximum test limit |
| $71 | $E6 | Multiply by 0.01 (kPa) | Test value of AIR pressure change for AIR valve | Minimum test limit | Maximum test limit |
| $71 | $E7 | Multiply by 0.01 (kPa) | Test value of AIR pressure change for AIR VSV bank 1 | Minimum test limit | Maximum test limit |
| $71 | $E8 | Multiply by 0.01 (kPa) | Test value of AIR pressure change for AIR VSV bank 2 | Minimum test limit | Maximum test limit |
| $71 | $E9 | Multiply by 0.01 (kPa) | Test value of AIR pressure pulsation for AIR VSV when AIR pressure is low | Minimum test limit | Maximum test limit |