LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GX 470 >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Vehicle Stability Control System >> DTC C0226/21, C0236/22, C0246/23, C0256/24, C1225/25, C1226/26, C1227/27, C1228/28: SFR Solenoid Circuit; SFL Solenoid Circuit; SRR Solenoid Circuit; SRL Solenoid Circuit; SMC Solenoid Circuit; SPC Solenoid Circuit; SRC Solenoid Circuit; STR Solenoid Circuit >> Inspection Procedure

Inspection Procedure

NOTE: When replacing the master cylinder solenoid, perform zero point calibration (See CALIBRATION  ).
  1. RECONFIRM DTC 

    HINT:

    These codes are detected when a problem is determined in the master cylinder solenoid.

    The solenoid circuit is in the master cylinder solenoid.

    Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.

    1. Clear the DTCs (See DTC CHECK/CLEAR  ).
    2. Drive the vehicle at a speed of approximately 20 mph (32 km/h) or more for 60 seconds or more.
    3. Check if the same DTCs are detected (See DTC CHECK/CLEAR  ).

    Result 

    RESULT TABLE

    Condition Proceed to
    DTC is output A
    DTC is not output B

    B: END 

    A: REPLACE MASTER CYLINDER SOLENOID 

scientia non olet · About LEMON Manuals