LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GX 470 >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Interior >> Roof Headlining >> Removal

Roof Headlining: Removal

  1. REMOVE NO. 2 REAR SEAT ASSEMBLY LH (w/ Rear No. 2 Seat) 

    HINT:

    SE-33

  2. REMOVE NO. 2 REAR SEAT ASSEMBLY RH (w/ Rear No. 2 Seat) 

    HINT:

    SE-33

  3. REMOVE FRONT DOOR SCUFF PLATE LH 
    1. Using a screwdriver, disengage the 6 claws and remove the scuff plate.

    HINT:

    Tape the screwdriver tip before use.

  4. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT:

    Use the same procedures described above for the LH side.

    Fig 1: Front Door Scuff Plate LH
    G05267155Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE COWL SIDE TRIM BOARD LH 
    1. Remove the cap nut.
    2. Using a screwdriver, disengage the 2 claws and remove the trim board.

      HINT:

      Tape the screwdriver tip before use.

  6. REMOVE COWL SIDE TRIM BOARD RH 

    HINT:

    Use the same procedures described above for the LH side.

    Fig 2: Cowl Side Trim Board Lh
    G05267156Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE QUARTER SCUFF PLATE INSIDE LH 
    1. Remove the 2 quarter scuff plate inner covers.
    2. Using a screwdriver, disengage the 4 claws and remove the scuff plate.

    HINT:

    Tape the screwdriver tip before use.

    Fig 3: Quarter Scuff Plate Inside LH
    G05267157Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE QUARTER SCUFF PLATE INNER RH 

    HINT:

    Use the same procedures described above for the LH side.

  9. REMOVE REAR DOOR SCUFF PLATE LH 
    1. Using a screwdriver, disengage the 4 claws and remove the scuff plate.
  10. REMOVE REAR DOOR SCUFF PLATE RH 

    HINT:

    Use the same procedures described above for the LH side.

    Fig 4: Quarter Scuff Plate Inner RH
    G05267158Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH 
  12. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH 
  13. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH 
  14. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH 
  15. REMOVE CENTER PILLAR GARNISH LOWER LH 
    1. Remove the front seat belt anchor bolt and front seat belt.
    2. Disengage the 2 clips and 2 claws, and remove the center pillar garnish.
  16. REMOVE CENTER PILLAR GARNISH LOWER RH 

    HINT:

    Use the same procedures described above for the LH side.

    Fig 5: Center Pillar Garnish Lower LH
    G05267159Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE CENTER PILLAR GARNISH LH 
    1. Remove the 2 screws.
    2. Disengage the 2 claws and clip, and remove the pillar garnish.
  18. REMOVE CENTER PILLAR GARNISH RH 

    HINT:

    Use the same procedures described above for the LH side.

    Fig 6: Center Pillar Garnish LH
    G05267160Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. REMOVE BACK DOOR WEATHERSTRIP 
  20. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE 
    1. Remove the 5 screws.
    2. Using a screwdriver, disengage the 2 claws and remove the mat support plate.

    HINT:

    Tape the screwdriver tip before use.

    Fig 7: Rear Floor Mat Rear Support Plate
    G05267161Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  21. REMOVE QUARTER INSIDE TRIM BOARD LH 
    1. Remove the luggage compartment hook by turning it clockwise.
    2. Remove the screw and quarter trim cover.
      Fig 8: Removing The Luggage Compartment Hook
      G05267162Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and the floor anchor part of the rear No. 1 seat belt assembly.
    4. Remove the 2 screws.
    5. Using a screwdriver, disengage the 8 clips and remove the trim board.

      HINT:

      Tape the screwdriver tip before use.

      Fig 9: Quarter Inside Trim Board LH
      G05267163Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  22. REMOVE QUARTER INSIDE TRIM BOARD RH 

    HINT:

    Use the same procedures described above for the LH side.

  23. REMOVE ROOF SIDE GARNISH INNER LH 
    1. Remove the floor anchor part of the seat No. 2 belt assembly.
    2. Using a screwdriver, firmly push the pin to disengage the clips (A).

      HINT:

      Tape the screwdriver tip before use.

    3. Using a screwdriver, disengage the 8 clips (B and C) and remove the garnish.

      HINT:

      • Tape the screwdriver tip before use.
      • The clip (A) cannot be reused.
      Fig 10: Roof Side Garnish Inner LH
      G05267164Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  24. REMOVE ROOF SIDE GARNISH INNER RH 

    HINT:

    Use the same procedures described above for the LH side.

  25. REMOVE FRONT PILLAR GARNISH LH 
    1. Remove the 2 grip plugs, 2 screws and assist grip.
    2. Using a screwdriver, disengage the clip and remove the garnish.

      HINT:

      Tape the screwdriver tip before use.

      Fig 11: Front Pillar Garnish LH
      G05267165Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull the garnish upward, and remove the pillar garnish from the instrument panel.
    4. w/ Curtain shield airbag: Protect the curtain shield airbag.
      1. Thoroughly cover the airbag with cloth or nylon of 700 mm (27.56 in.) x 120 mm (4.72 in.) and fix the ends of the cover with adhesive tape, as shown in the illustration.
      NOTE: Cover the curtain shield airbag with the protection cover as soon as the front pillar garnish is removed.
  26. REMOVE FRONT PILLAR GARNISH RH 

    HINT:

    Use the same procedures described above for the LH side.

    Fig 12: Fixing Ends Of Cover With Adhesive Tape
    G05267166Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  27. REMOVE ASSIST GRIP ASSEMBLY 
    1. Using a screwdriver, disengage the 4 claws and remove the 2 assist grip plugs.

      HINT:

      Tape the screwdriver tip before use.

    2. Remove the 2 screws and assist grip.

    HINT:

    • w/o Rear No. 2 Seat: Remove the 4 assist grips.
    • w/ Rear No. 2 Seat: Remove the 6 assist grips.
    Fig 13: Removing Assist Grip Assembly
    G05267167Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  28. REMOVE ROOF CONSOLE BOX SUB-ASSEMBLY 
    1. Using a screwdriver, disengage the 3 claws and 2 clips, and remove the console box assembly.

      HINT:

      Tape the screwdriver tip before use.

    2. Disconnect the connectors.
    Fig 14: Identifying Claws And Clips On Console Box Assembly
    G05267168Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  29. REMOVE TELEVISION BASE (w/ Rear Seat Entertainment System) 
    1. Remove the 2 lenses.
    2. Remove the 2 bolts.
    3. Disengage the 4 clips.
    4. Disconnect the connector and remove the television base.
    5. Disconnect the television display connector.
    Fig 15: Identifying Bolts And Clips On Television Base
    G05266230Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  30. REMOVE NO. 1 INTERIOR LIGHT ASSEMBLY (w/o Rear Seat Entertainment System) 
    1. Using a screwdriver, remove the lens cover.
    2. Using a screwdriver, disengage the 4 claws and remove the interior light assembly, as shown in the illustration.

      HINT:

      Tape the screwdriver tip before use.

    3. Disconnect the interior light connector.
    Fig 16: Removing No.1 Interior Light Assembly (W/O Rear Seat Entertainment System)
    G05267170Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  31. REMOVE NO. 2 INTERIOR LIGHT ASSEMBLY 
    1. Using a screwdriver, remove the lens cover.
    2. Using a screwdriver, disengage the 4 claws and remove the interior light assembly, as shown in the illustration.

      HINT:

      Tape the screwdriver tip before use.

    3. Disconnect the interior light connector.
    Fig 17: Removing No. 2 Interior Light Assembly
    G05267171Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  32. REMOVE ROOF HEADLINING REAR TRIM COVER LH (w/ Rear No. 2 Seat) 
    1. Pull out the seat belt buckle from the roof headlining trim cover.
    2. Using a roof moulding remover, disengage the 6 claws and remove the roof headlining trim cover.
    Fig 18: Identifying Claws On Roof Headlining Trim Cover
    G05267172Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  33. REMOVE VISOR BRACKET COVER 
    1. Using a screwdriver, disengage the 4 claws and remove the visor bracket cover.

    HINT:

    • Tape the screwdriver tip before use.
    • Use the same procedure to remove the visor bracket cover on the other side.
    Fig 19: Identifying Claws On Visor Bracket Cover
    G05267173Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  34. REMOVE VISOR ASSEMBLY LH 
    1. Remove the 2 screws and visor assembly.
  35. REMOVE VISOR ASSEMBLY RH 
    1. Remove the 2 screws and visor assembly.
  36. REMOVE CENTER VISOR ASSEMBLY LH 
    1. Remove the 2 screws and center visor assembly.
  37. REMOVE CENTER VISOR ASSEMBLY RH 
    1. Remove the 2 screws and center visor assembly.
  38. REMOVE VISOR HOLDER 
    1. Remove the screw and visor holder.

    HINT:

    Use the same procedure to remove the visor holder on the other side.

  39. REMOVE COAT HOOK 
    1. Remove the bolt and coat hook.

    HINT:

    Use the same procedure to remove the hook on the other side.

  40. REMOVE COAT HOOK (w/o Rear No. 2 Seat) 
    1. Remove the 2 bolt and coat hook.

    HINT:

    Use the same procedure to remove the hook on the other side.

  41. REMOVE ROOF HEADLINING ASSEMBLY 
  42. REMOVE ROOF SIDE AIR OUTLET REGISTER 
    1. Remove the screw and register.
scientia non olet · About LEMON Manuals