LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 450h >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper & Washer >> Wiper Switch >> Installation

Wiper Switch: Installation

  1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY 
    1. Attach the claw and install the wiper switch.
    2. Connect the connector.
      3. Fig 1: Identifying Claw On Wiper Switch
      G05310882Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE WITH STEERING SENSOR  (See INSTALLATION )
  3. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  4. ADJUST SPIRAL CABLE WITH STEERING SENSOR  (See INSTALLATION )
  5. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  6. INSPECT STEERING WHEEL CENTER POINT 
  7. INSTALL STEERING PAD  (See INSTALLATION )
  8. INSTALL NO. 3 STEERING WHEEL COVER LOWER 
  9. INSTALL NO. 2 STEERING WHEEL COVER LOWER 
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  11. INSPECT STEERING PAD  (See DISPOSAL )
  12. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  13. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM (2006/02-2006/07) ).
scientia non olet · About LEMON Manuals