Front Stereo Component Speaker: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL FRONT STEREO COMPONENT SPEAKER ASSEMBLY 
   1. Connect the speaker connector.
   2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
   3. Install the speaker with the 2 bolts.
      NOTE: Do not touch the cone part of the speaker.
      Fig 1: Identifying Front Stereo Component Speaker Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL SPEAKER HOLE COVER 
   1. Attach the 4 clips to install the hole cover.
      Fig 2: Identifying Hole Cover Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
4. PERFORM INITIALIZATION 
   1. Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.