Floor Shift Assembly: Adjustment

ADJUST SHIFT LEVER POSITION
1. Remove the nut and disconnect the shifting rod.
  
  Fig 1: Locating Shift Lever Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the control shaft lever of the park/neutral position switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
3. Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.
  Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
  
  NOTE: Do not push the shift lever too hard.
4. After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.
Fig 2: Turning Control Shaft Lever Of Park/Neutral Position Switch
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002