LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 350 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Control System (3UZ-FE)) >> Camshaft Timing Oil Control Valve Assembly >> Installation

Camshaft Timing Oil Control Valve Assembly: Installation

WARNING: This page is about a different car, the 2007 Lexus GS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY LH 
    1. Install a new O-ring to the oil control valve.
    2. Install the oil control valve with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

    3. Connect the oil control valve connector.
      Fig 1: Locating Bolt And Oil Control Valve
      G05291577Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY RH 
    1. Install a new O-ring to the oil control valve.
    2. Install the oil control valve with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

    3. Connect the oil control valve connector.
      Fig 2: Locating Bolt And Oil Control Valve
      G05291575Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL INTAKE AIR CONNECTOR PIPE 
    1. Install the intake air connector pipe with the bolt and 2 hose clamps.
      Fig 3: Locating Intake Air Connector Pipe With Bolt And Hose Clamps
      G05285771Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 4.0 N*m (41 kgf*cm, 35 in.*lbf) for hose clamp 

      5.0 N*m (51 kgf*cm, 44 in.*lbf) for bolt 

    2. Connect the air hose and No. 1 ventilation hose.
  4. INSTALL NO. 1 AIR CLEANER INLET 
    1. Install the air cleaner inlet and bolt.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

  5. INSTALL V-BANK COVER 
    1. Install the V-bank cover with the 2 nuts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

  6. INSTALL ENGINE ROOM SIDE COVER LH 
    1. Install the side cover with the 3 clips.
      Fig 4: Identifying Clips And Side Cover
      G05285764Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL ENGINE ROOM SIDE COVER RH 
    1. Install the side cover with the 2 clips and nut.
      Fig 5: Locating Nut, 2 Clips And Side Cover
      G05285773Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. INSTALL COOL AIR INTAKE DUCT SEAL 
    1. Install the intake duct seal with the 7 clips.
      Fig 6: Identifying Clips And Intake Duct Seal
      G05285762Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  10. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals