HEATED OXYGEN SENSOR (for Sensor 2): Installation

WARNING: This page is about a different car, the 2007 Lexus GS 430. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HEATED OXYGEN SENSOR (for Bank 1)
1. Using SST, install the sensor.
  SST 09224-00010
  
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST
  
  HINT:
  
  Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
2. Pass the sensor connector through the floor panel and into the cabin, and install the grommet.
3. Connect the sensor connector.
Fig 1: Installing Heated Oxygen Sensor (For Bank 1)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Identifying Grommet
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEATED OXYGEN SENSOR (for Bank 2)
1. Using SST, install the sensor.
  SST 09224-00010
  
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf) for use without ST
  
  HINT:
  
  Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
  
  Fig 3: Installing Heated Oxygen Sensor (For Bank 2)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pass the sensor connector through the floor panel and into the cabin, and install the grommet.
3. Connect the sensor connector.
  
  Fig 4: Connecting Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See INSTALLATION )
INSTALL FRONT ASH RECEPTACLE ASSEMBLY (See INSTALLATION )
INSTALL FRONT CONSOLE UPPER PANEL GARNISH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.