LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 350 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Ignition (3UZ-FE)) >> Ignition Coil >> Removal

Ignition Coil: Removal

WARNING: This page is about a different car, the 2007 Lexus GS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  3. REMOVE ENGINE ROOM SIDE COVER RH (See  REMOVAL  ) 
  4. REMOVE ENGINE ROOM SIDE COVER LH (See  REMOVAL  ) 
  5. REMOVE NO. 1 AIR CLEANER INLET 
  6. REMOVE V-BANK COVER 
    1. Remove the 2 nuts and V-bank cover.
  7. REMOVE IGNITION COIL 
    1. Disconnect the ignition coil connector.
    2. Remove the bolt and pull out the ignition coil.
    Fig 1: Locating Ignition Coil
    G05287703Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals