LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 350 RWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel (2GR-FSE) >> Fuel Pressure Pulsation Damper >> Removal

Fuel Pressure Pulsation Damper: Removal

  1. (See PRECAUTION  )
  2. DISCHARGE FUEL SYSTEM PRESSURE (See  REMOVAL  ) 
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  4. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  5. REMOVE ENGINE ROOM SIDE COVER LH (See  REMOVAL  ) 
  6. REMOVE ENGINE ROOM SIDE COVER RH (See  REMOVAL  ) 
  7. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH (See  REMOVAL  ) 
  8. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH (See  REMOVAL  ) 
  9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH (See  REMOVAL  ) 
  10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH (See  REMOVAL  ) 
  11. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See  REMOVAL  ) 
  12. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See  REMOVAL  ) 
  13. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See  REMOVAL  ) 
  14. REMOVE V-BANK COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  15. DISCONNECT NO. 2 VENTILATION HOSE (See  REMOVAL  ) 
  16. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE (See  REMOVAL  ) 
  17. REMOVE FUEL PRESSURE PULSATION DAMPER 
    1. Using SST, remove the fuel pressure pulsation damper and 2 gaskets, and disconnect the fuel tube from the fuel pump.

      SST 09612-24014 (09617-24011) 

scientia non olet · About LEMON Manuals