LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 350 RWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting (2GR-FSE) >> Engine Switch >> Removal

Engine Switch: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH (See  REMOVAL  ) 
  3. REMOVE FRONT CONSOLE UPPER PANEL ASSEMBLY (See  REMOVAL  ) 
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See  REMOVAL  ) 
  5. REMOVE FRONT DOOR SCUFF PLATE LH (See  REMOVAL  ) 
  6. REMOVE FRONT DOOR OPENING TRIM COVER LH (See  REMOVAL  ) 
  7. REMOVE INSTRUMENT SIDE PANEL LH (See  REMOVAL  ) 
  8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY (See  REMOVAL  ) 
  9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (See  INSTALLATION  ) 
  10. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  11. REMOVE ENGINE SWITCH 
    1. Disconnect the switch connector.
    2. Detach the 2 claws and remove the switch.
      Fig 1: Locating Engine Switch Connector With Claw
      G05287836Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals