Data List / Active Test
- DATA LIST
- Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- Warm up the engine.
- Turn the engine switch off.
- Connect the intelligent tester to the DLC3.
- Turn the engine switch on (IG).
- Operate the intelligent tester according to the display and select "DATA LIST".
Combination meter:
DATA LISTTester Display Measurement Item/Range Normal Condition Diagnostic Note SPEED METER Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed (When driving) - TACHO METER Engine speed / Min.: 0 rpm, Max.: 12,750 rpm Almost same as actual engine speed (When engine is running) - FUEL GAUGE Fuel input signal Min.: 0, Max.: 255 Fuel gauge indicates (F): 47
Fuel gauge indicates (3/4): 92
Fuel gauge indicates (1/2): 148
Fuel gauge indicates (1/4): 187
Fuel gauge indicates (E): 205- ECD Sunlight Sensor ECD sunlight sensor input value/ Min.: 0, Max.: 255 50 to 195 - Permeation Reaction ECD sunlight level input value/
Min.: 0, Max.: 9ECD permeation level
Min.: 3, Max.: 0- KEY REMND VOLUM Key remind volume/ LARGE, MEDIUM or SMALL - - KEY REMND SOUND Key remind sound/ FAST, NORMAL, SLOW - - ECM (3GR-FSE):
DATA LISTTester Display Measurement Item/Range Normal Condition Diagnostic Note ENGINE SPD Engine speed/
Min.: 0 rpm, Max.: 16,383 rpmAlmost same as actual engine speed (When engine is running) - COOLANT TEMP Engine coolant temperature/
Min.: -40°C, Max.: 140°CAfter warming up: 80 to 105°C (176 to 221°F) If value is -40°C (-40°F), sensor circuit is open.
If value is 140°C (284°F), sensor circuit is shorted.ECM (3UZ-FE):
DATA LISTTester Display Measurement Item/Range Normal Condition Diagnostic Note ENGINE SPD Engine speed/
Min.: 0 rpm, Max.: 16,383 rpmAlmost same as actual engine speed (When engine is running) - COOLANT TEMP Engine coolant temperature /
Min.: -40°C, Max.: 140°CAfter warming up: 75 to 95°C (167 to 203°F) If value is -40°C (-40°F), sensor circuit is open.
If value is 140°C (284°F), sensor circuit is shorted.Integration control and panel assembly:
DATA LISTTester Display Measurement Item/Range Normal Condition Diagnostic Note ODO/TRIP SWITCH ODO/TRIP switch/ ON or OFF ON: Switch is pushed
OFF: Switch is not pushed- TRIP RESET SWITCH Trip reset switch/ ON or OFF ON: Switch is pushed
OFF: Switch is not pushed- RHEOSTAT UP SWITCH Rheostat up switch/ ON or OFF ON: Switch is pushed
OFF: Switch is not pushed- RHEOSTAT DOWN SWITCH Rheostat down switch/ ON or OFF ON: Switch is pushed
OFF: Switch is not pushed- - Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- ACTIVE TEST
- Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.
- Connect the intelligent tester to the DLC3.
- Turn the engine switch on (IG).
- From the display on tester, perform the "ACTIVE TEST".
Combination meter:
ACTIVE TESTTester Display Test Part Control Range SPEED METER 0 / 40 (24) / 80 (48) /120 (72) /160 (96) / 200 (120) / 240 (144) km/h (mph) - TACHOMETER 0 rpm /1,000 rpm / 2,000 rpm / 3,000 rpm / 4,000 rpm / 5,000 rpm / 6,000 rpm / 7,000 rpm - FUEL GAUGE EMPTY, 1/2, FULL - COOLANT TEMP LOW / NORMAL / HIGH - LOW FUEL WARN Indicat. Light FUEL (OFF/ON) Confirm that the vehicle is stopped and engine idling OPEN DOOR WARN Indicat. Light DOOR (OFF/ON) Confirm that the vehicle is stopped and engine idling P-BELT REMIND Indicat. Light P-SEAT BELT (OFF/ON) Confirm that the vehicle is stopped and engine idling D-BELT REMIND Indicat. Light D-SEAT BELT (OFF/ON) Confirm that the vehicle is stopped and engine idling DISCHARGE WARN Indicat. Light CHARGE (OFF/ON) Confirm that the vehicle is stopped and engine idling BRAKE WARN Indicat. Light BRAKE (OFF/ON) Confirm that the vehicle is stopped and engine idling TAILLIGHT INDIC Indicat. Light TAIL (OFF/ON) Confirm that the vehicle is stopped and engine idling CRUISE INDIC Indicat. Light CRUISE (OFF/ON) Confirm that the vehicle is stopped and engine idling ECT SNOW INDIC Indicat. Light ECR SNOW (OFF/ON) Confirm that the vehicle is stopped and engine idling ECT PWR INDIC Indicat. Light ECT PWR (OFF/ON) Confirm that the vehicle is stopped and engine idling VSC WARN Indicat. Light VSC (OFF/ON) Confirm that the vehicle is stopped and engine idling SRS WARN Indicat. Light AIRBAG (OFF/ON) Confirm that the vehicle is stopped and engine idling HIGH BEAM INDIC Indicat. Light BEAM (OFF/ON) Confirm that the vehicle is stopped and engine idling ABS WARN Indicat. Light ABS (OFF/ON) Confirm that the vehicle is stopped and engine idling SLIP INDIC Indicat. Light SLIP (OFF/ON) Confirm that the vehicle is stopped and engine idling Fr FOG INDIC Indicat. Light Fr FOG (OFF/ON) Confirm that the vehicle is stopped and engine idling TIRE PRESS WARN Indicat. Light TIRE PRESS (OFF/ON) Confirm that the vehicle is stopped and engine idling KEY REMND BUZZER Key reminder buzzer (OFF/ON) Confirm that the vehicle is stopped and engine idling LGT REMND BUZZER Light reminder buzzer (OFF/ON) Confirm that the vehicle is stopped and engine idling SEAT BELT BUZZER Seat belt buzzer (OFF/ON) Confirm that the vehicle is stopped and engine idling S SHFT RJCT BUZZER Sports shift reject buzzer (OFF/ON) Confirm that the vehicle is stopped and engine idling WARNING BUZZER Warning buzzer (OFF/ON) Confirm that the vehicle is stopped and engine idling A/T SHIFT LCD A/T shift LCD (OFF/ON) Confirm that the vehicle is stopped and engine idling AFS INDICATOR Indicat. Light AFS (OFF/ON) Confirm that the vehicle is stopped and engine idling CSONAR LCD DISP Indicat. clearance sonar (OFF/ON) Confirm that the vehicle is stopped and engine idling TEMS is i INDIC Indicat. tems sports (OFF/ON) Confirm that the vehicle is stopped and engine idling EPS INDIC Indicat. Emps (OFF/ON) Confirm that the vehicle is stopped and engine idling Electronically Controlled Brake System INDIC Indicat. Electronically controlled brake system (OFF/ON) Confirm that the vehicle is stopped and engine idling MST WARN INDICATOR Master warning (OFF/ON) Confirm that the vehicle is stopped and engine idling MULTI - DISP Multi-display (OFF/ON) Confirm that the vehicle is stopped and engine idling ECD ON INDIC Indicat. ECD ON (OFF/ON) Confirm that the vehicle is stopped and engine idling - Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.