LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 350 RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Brake Pedal >> Removal

Brake Pedal: Removal

  1. PRECAUTION 

    (See PRECAUTION )

  2. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  3. REMOVE ENGINE ROOM SIDE COVER LH (See  REMOVAL  ) 
  4. REMOVE ENGINE ROOM COVER SIDE (See  FUEL PUMP CONTROL CIRCUIT  ) 
  5. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH (See  REMOVAL  ) 
  6. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH (See  REMOVAL  ) 
  7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See  REMOVAL  ) 
  8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See  REMOVAL  ) 
  9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH (See  REMOVAL  ) 
  10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH (See  REMOVAL  ) 
  11. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See  REMOVAL  ) 
  12. PERFORM ACCUMULATOR ZERO DOWN (for 3UZ-FE) (See  BRAKE FLUID (FOR 3UZ-FE)  ) 
  13. DISABLE BRAKE CONTROL OFF (for 3UZ-FE) (See  BRAKE FLUID (FOR 3UZ-FE)  ) 
  14. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  15. SEPARATE ENGINE ROOM RELAY NO.3 BLOCK (for 2GR-FSE) (See  REMOVAL  ) 
  16. REMOVE FRONT WHEEL 
  17. DRAIN BRAKE FLUID 
    NOTE: If brake fluid leaks onto any painted surface, wash or otherwise remove it completely.
  18. REMOVE CONSOLE UPPER PANEL GARNISH FRONT (See  REMOVAL  ) 
  19. REMOVE CONSOLE PANEL UPPER PANEL SUB-ASSEMBLY (See  REMOVAL  ) 
  20. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See  REMOVAL  ) 
  21. REMOVE FRONT DOOR SCUFF PLATE LH (See  REMOVAL  ) 
  22. REMOVE FRONT DOOR OPENING TRIM COVER LH (See  REMOVAL  ) 
  23. REMOVE INSTRUMENT SIDE PANEL LH (See  REMOVAL  ) 
  24. REMOVE INSTRUMENT PANEL UNDER COVER NO.1 SUB-ASSEMBLY (See  REMOVAL  ) 
  25. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY NO.1 (See  REMOVAL  ) 
  26. REMOVE INSTRUMENT PANEL AIR BAG ASSEMBLY NO.1 LOWER (See  INSTALLATION  ) 
  27. REMOVE BRAKE MASTER WITH PLATE CYLINDER SUB-ASSEMBLY (for 2GR-FSE) (See  BRAKE MASTER CYLINDER (FOR 2GR-FSE)  ) 
  28. REMOVE ABS AND TRACTION ACTUATOR ASSEMBLY (for 2GR-FSE) (See  DISASSEMBLY  ) 
  29. REMOVE SKID CONTROL ECU ASSEMBLY (for 3UZ-FE) (See  REMOVAL  ) 
  30. REMOVE BRAKE ACTUATOR ASSEMBLY WITH ACTUATOR BRACKET (for 3UZ-FE) (See  REMOVAL  ) 
  31. REMOVE RESERVOIR TUBE NO.1 HOSE (for 3UZ-FE) (See  REMOVAL  ) 
  32. REMOVE BRAKE PEDAL RETURN SPRING (for 3UZ-FE) (See  REMOVAL  ) 
  33. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS (for 3UZ-FE) (See  REMOVAL  ) 
  34. REMOVE BRAKE MASTER CYLINDER ASSEMBLY WITH STROKE SIMULATOR (for 3UZ-FE) (See  REMOVAL  ) 
  35. REMOVE BRAKE BOOSTER GASKET (for 3UZ-FE) (See  REMOVAL  ) 
  36. REMOVE BRAKE PEDAL RETURN SPRING (for 2GR-FSE) (See  REMOVAL  ) 
  37. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS (for 2GR-FSE) (See  REMOVAL  ) 
  38. REMOVE BRAKE BOOSTER ASSEMBLY (for 2GR-FSE) (See  REMOVAL  ) 
  39. REMOVE BRAKE BOOSTER GASKET (for 2GR-FSE) 
    1. Remove the brake booster gasket.
  40. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY (for 2GR-FSE) 
    1. Disconnect the 2 connectors.
    2. Disengage the wire harness clamp.
      Fig 1: Locating Connectors And Wire Harness Clamp
      G05297234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and brake pedal support assembly.
      Fig 2: Locating Brake Pedal Support Assembly With Bolt
      G05297235Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  41. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY (for 3UZ-FE) 
    1. Disconnect the 3 connectors.
    2. Disengage the wire harness clamp.
      Fig 3: Locating Wire Harness Clamp
      G05297236Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and brake pedal support assembly.
      Fig 4: Locating Bolt And Brake Pedal Support Assembly
      G05279519Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals