LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 350 RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> BRAKE MASTER CYLINDER (for 3UZ-FE) >> Disassembly

BRAKE MASTER CYLINDER (for 3UZ-FE): Disassembly

  1. REMOVE BRAKE MASTER CYLINDER ASSEMBLY 
    1. Using SST, separate the brake stroke simulator tube from the brake stroke simulator cylinder sub-assembly.

      SST 09023-00101 

    2. Remove the 2 nuts, 2 brake master cylinder gaskets, brake master cylinder bracket and brake stroke simulator bracket.
    Fig 1: Locating Brake Master Cylinder Assembly
    G05297267Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE BRAKE MASTER CYLINDER RESERVOIR 
    1. Remove the screw and brake master cylinder reservoir assembly.
    2. Remove the 2 master cylinder reservoir grommets.
  3. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS 
    1. Remove the push rod clevis and lock nut.
    Fig 2: Locating Brake Master Cylinder Reservoir With Screw
    G05297268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE BRAKE STROKE SIMULATOR CYLINDER SUB-ASSEMBLY 
    1. Separate the connector from the brake stroke simulator bracket.
    2. Remove the 2 bolts and the brake stroke simulator cylinder sub-assembly from the brake stroke simulator bracket.
    Fig 3: Locating Brake Stroke Simulator Cylinder To Brake Simulator Bracket With Bolts
    G05297269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals