LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> GS 350 RWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat >> Rear Seat Assembly >> Installation

Rear Seat Assembly: Installation

  1. INSTALL REAR SEATBACK ASSEMBLY 
    1. Place the seatback in the cabin.
      NOTE: Be careful not to damage the vehicle body.
    2. Install the seatback with the 4 bolts and 2 nuts.
      Fig 1: Installing Rear Seatback Assembly
      G05300569Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 18.1 N*m (185 kgf*cm, 13 ft.*lbf) 

    3. Install the 2 rear seat covers.
    4. Pass the 3 seat belts through and close the cap of the 3 rear seat shoulder belt guides.
    5. Install the floor anchor part with the bolt.
  2. INSTALL REAR SEAT HEADREST ASSEMBLY CENTER 
  3. INSTALL REAR SEAT HEADREST ASSEMBLY LH AND RH 
  4. INSTALL REAR SEAT CUSHION ASSEMBLY 
    1. Attach the seat cushion's 2 rear hooks to the seatback.
    2. Attach the seat cushion's 2 front hooks to the vehicle body.
    3. Confirm that the seat cushion is firmly installed.
      NOTE: When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.
    Fig 2: Installing Rear Seat Cushion Assembly
    G05300586Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals