Front Stereo Component Speaker: Inspection

INSPECT FRONT STEREO COMPONENT SPEAKER ASSEMBLY

With the speaker installed, check that there is no looseness or other abnormalities.
Check that there is no foreign matter in the speaker, no tears on the speaker's cone part, or other abnormalities.

Measure the resistance of the speaker.

Standard resistance (Standard models)

RESISTANCE SPECIFICATION

Tester Connection	Specified Condition
1 - 2	8 Ω

Standard resistance (Mark Levinson models)

RESISTANCE SPECIFICATION

Tester Connection	Specified Condition
1 - 2	8 Ω

If the result is not as specified, replace the speaker assembly.

Fig 1: Identifying Front Stereo Component Speaker Connector Terminals