Front No. 2 Speaker: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (See SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY 
   Fig 1: Locating Front No 2 Speaker Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Connect the connector.
   2. Temporarily install the speaker by aligning the positioning pins of the speaker to the instrument panel.
   3. Install the speaker with the 2 bolts.

      HINT:

      Do not touch the cone part of the speaker.

2. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY 
   1. Attach the 2 clips and 2 claws to install the panel.
      Fig 2: Identifying Instrument Panel Speaker Panel Clips And Claws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
4. PERFORM INITIALIZATION 
   1. Perform initialization (See INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.