Front Bumper: Removal

REMOVE COOL AIR INTAKE DUCT SEAL
1. Remove the 7 clips and cool air intake duct seal.
  
  Fig 1: Identifying Cool Air Intake Duct Seal Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER ASSEMBLY
1. Put protective tape around the front bumper assembly.
  
  Fig 2: Putting Protective Tape Around Front Bumper Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.
  HINT:
  
  Use the same procedures for the RH side and LH side.
  
  Fig 3: Removing Pin Hold Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 9 screws, 2 clips, 2 radiator grille protectors and bolt.
  
  Fig 4: Identifying Radiator Grille Protectors Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disengage the 3 claws and disconnect the front bumper assembly as shown in the illustration.
  HINT:
  
  Use the same procedures for the RH side and LH side.
5. Disconnect each connector, and then remove the front bumper assembly.
  
  Fig 5: Identifying Front Bumper Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002