LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> RX 400h FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Driver Side Knee Airbag Assembly >> Removal

Driver Side Knee Airbag Assembly: Removal

  1. PRECAUTION 
    CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
  3. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER (See  REMOVAL  ) 
  4. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY 
    1. Disconnect the connector from the driver side knee airbag assembly.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
    2. Remove the 4 bolts and the driver side knee airbag assembly.
      Fig 1: Identifying Driver Side Knee Airbag Assembly
      G04114564Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals