Brake Master Cylinder: Disassembly

REMOVE BRAKE TUBE
1. Using SST, disconnect the brake tube.
  SST 09023-00101
  
  Fig 1: Disconnecting Brake Tube Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BRAKE MASTER CYLINDER
1. Remove the 2 nuts, 2 brake master cylinder gaskets, brake master cylinder bracket, brake master cylinder and brake stroke simulator bracket.
Fig 2: Identifying Brake Master Cylinder
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE MASTER CYLINDER PUSH ROD CLEVIS
1. Remove the push rod clevis and lock nut.
  HINT:
  
  Adjustment of brake pedal height is easier when reassembling the brake master w/ simulator cylinder assembly afterward, if the protrusion of the push rod from push rod clevis is measured and recorded at this stage.
REMOVE BRAKE STROKE SIMULATOR CYLINDER SUB-ASSEMBLY
1. Disconnect the connector from the bracket.
2. Remove the 2 bolts and the brake stroke simulator cylinder from the brake stroke simulator bracket.
  
  Fig 3: Identifying Brake Stroke Simulator Cylinder Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002