LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> RX 400h FWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat >> REAR SEAT ASSEMBLY (for RH Side) >> Removal

REAR SEAT ASSEMBLY (for RH Side): Removal

  1. REMOVE REAR SEAT TRACK BRACKET COVER 
    1. Move the rear seat assembly RH to the rearmost position by operating the rear seat track adjusting handle.
    2. Using a screwdriver, disengage the 4 claws.

      HINT:

      Tape the screwdriver tip before use.

    3. Pull the 2 rear seat track bracket covers toward the rear of the vehicle and remove them.
      Fig 1: Identifying Rear Seat Track Bracket Cover
      G04116308Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE REAR SEAT ASSEMBLY RH 
    1. Using a clip remover, remove the 5 clips.
    2. Remove the bolt and disconnect the floor anchor side of the fold seat stopper band assembly No. 1.
    3. Move the rear seat assembly RH to the rearmost position by operating the rear seat track adjusting handle.
    4. Remove the 2 bolts on the front side.
    5. Move the rear seat assembly RH fully forward by operating the rear seat track adjusting handle.
    6. Remove the 3 bolts on the rear side.
    7. Move the rear seat assembly RH to the center position and adjust the seatback to the vertical position.
    8. Remove the rear seat assembly RH.
scientia non olet · About LEMON Manuals