Inspection Procedure
- PERFORM ACTIVE TEST BY INTELLIGENT TESTER
- Operate the intelligent tester according to the steps on the display and select "ACTIVE TEST".
METER:
METERItem Test Details Diagnostic Note COOLANT TEMP LOW / NORMAL / HI - OK: Needle indication is normal.
NG : REPLACE COMBINATION METER ASSEMBLY
OK : GO TO NEXT STEP
- Operate the intelligent tester according to the steps on the display and select "ACTIVE TEST".
- READ VALUE OF INTELLIGENT TESTER
- Operate the intelligent tester according to the steps on the display and select "DATA LIST".DATA LIST
Item Measurement Item/Range (Display) Normal Condition Diagnostic Note WATER TEMP Engine coolant temp: -40°C (-40°F) to 140°C (284°F) After warming up: 80 to 95°C (176 to 203°F -
NG : GO TO SFI SYSTEM
OK : GO TO NEXT STEP
- Operate the intelligent tester according to the steps on the display and select "DATA LIST".
- REPLACE COMBINATION METER ASSEMBLY
NG : GO TO SFI SYSTEM
OK : END