Circuit Description
WARNING: This page is about a different car, the 2006 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
Refer to DTC C0200/31, C0205/32, C1235/35, AND C1236/36
.
DIAGNOSTIC TROUBLE CODE TABLE
| DTC No. |
DTC Detection Condition |
Trouble Area |
C0210/33
C0215/34 |
When any of the following conditions is detected:
- At a vehicle speed of 6 mph (10 km/h) or more, pulses are not input for 1 second.
- Momentary interruption of the speed sensor signal occurs at least 255 times when switching the ignition switch ON and OFF.
- Continuous noise occurs in speed sensor signals at a vehicle speed of 12 mph (20 km/h) or more.
- Speed sensor signal circuit is open for 0.12 seconds or more.
- 3 of the wheel sensors detect normal reversing signals, and the other wheel sensor detects malfunction signals 75 times with IG ON while reversing at 3 km/h.
- Rotating direction of each wheel changes 7 times within 0.006 seconds with IG ON while driving at 10 km/h or more.
- Rotating direction of one of the wheels is not the same as that of the other wheels for 1 second while driving at 30 km/h or more.
- Reversing signal is output for 1 second or more while driving at 100 km/h or more.
- Rotating direction of one of the wheels is not detected normally, and the rotating direction of each of the other wheels is not the same for 1 second while driving at 30 km/h or more.
|
- Right rear and left rear speed sensor
- Each speed sensor circuit
- Speed sensor rotor
- Sensor installation
- Master cylinder solenoid
|
C1238/38
C1239/39 |
Continuous noise occurs in speed sensor signals when vehicle speed is 12 mph (20 km/h) or more for 5 seconds or more. |
- Right rear and left rear speed sensor
- Speed sensor rotor
- Sensor installation
- Master cylinder solenoid
|
HINT:
- DTC C0210/33 and C1238/38 are for the right rear speed sensor.
- DTC C0215/34 and C1239/39 are for the left rear speed sensor.