LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> LX 470 >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Instrument Panel Safety Pad >> Disassembly

Instrument Panel Safety Pad: Disassembly

  1. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT 
  2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT 
  3. REMOVE DEFROSTER NOZZLE ASSEMBLY 
  4. REMOVE CENTER BRACKET 
  5. REMOVE NO. 1 HEATER TO REGISTER DUCT 
  6. REMOVE INSTRUMENT PANEL WIRE HARNESS 
  7. REMOVE NO. 5 HEATER TO REGISTER DUCT 
  8. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY 
    1. Remove the 3 nuts and the front passenger airbag assembly.

      Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

      CAUTION:
      • Do not store the front passenger airbag assembly with the airbag deployment side facing down.
      • Never disassemble the front passenger airbag assembly.
    2. At the time of reassembly:
      NOTE:
      • Make sure that the front passenger airbag assembly is installed with the specified torque.
      • If the front passenger airbag assembly has been dropped, or if there are cracks, dents or other defects in the case or the connector, replace the front passenger airbag assembly with a new one.
      • When installing the front passenger airbag assembly, take care that the wiring does not interfere with other parts and is not pinched between other parts.
  9. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY 
  10. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY 
scientia non olet · About LEMON Manuals