Tire And Wheel System: Inspection

INSPECT TIRES

Check the tires for wear and proper inflation pressure.

Cold tire inflation pressure

INFLATION PRESSURE

Tire Size

Specified Value kPa (kgf/cm² , psi)

Front

Rear

205/55R16 89W

240 (2.4, 35)

260 (2.6, 38)

225/45R17 91V

225/45R17 90W ⁽¹⁾

240 (2.4, 35)

245/45R17 95W ⁽²⁾

260 (2.6, 38)

225/45R17 95V ⁽¹⁾

240 (2.4, 35)

245/45R17 95V ⁽²⁾

260 (2.6, 38)

225/40R18 88Y ⁽¹⁾

240 (2.4, 35)

255/40R 18 95Y ⁽²⁾

260 (2.6, 38)

⁽¹⁾	Only for front tires

⁽²⁾	Only for rear tires

ROTATE TIRES
HINT:
- If the rotating direction of the tires is specified, rotate the tires as shown in Fig 2.
- 2WD models with 17-inch tires or 18-inch tires cannot be rotated.
  
  Fig 2: Tires Rotating Procedure
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT WHEEL BALANCE
1. Check and adjust the off-the-car balance.
  
  Fig 3: Inspecting Wheel Balance
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. If necessary, check and adjust the on-the-car balance.
  Imbalance after adjustment:
  
  8.0 g (0.018 lb.) or less.
  
  HINT:
  
  In the case of 16-inch wheels, balance weight should be installed by tapping.
  
  Fig 4: Adjusting On Car Balance
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Remove dirt, oil and water from the surface where the balance weight is to be adhered with a cleaning detergent.
  - Do not touch the sticking surface of the tape.
  - Adhere the sticking type balance weight to the flat position shown in Fig 4.
  - Push the balance weight securely with a finger to adhere it to the position.
  - Do not reuse a balance weight.
  - Please use the LEXUS genuine sticking type balance weight.
INSPECT FRONT AXLE DEVIATION AND BACKLASH
HINT:

(See ON-VEHICLE INSPECTION FOR FRONT AXLE, ON-VEHICLE INSPECTION FOR REAR AXLE)
INSPECT REAR AXLE DEVIATION AND BACKLASH
HINT:

(See ON-VEHICLE INSPECTION FOR FRONT AXLE, ON-VEHICLE INSPECTION FOR REAR AXLE)