LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission (A960E)) >> Valve Body Assembly >> Removal

Valve Body Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN AUTOMATIC TRANSMISSION FLUID (See  REMOVAL   ) 
  2. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See  REMOVAL   ) 
  3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See  REMOVAL   ) 
  4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY (See  REMOVAL   ) 
  5. DISCONNECT TRANSMISSION WIRE (See  REMOVAL   ) 
  6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY 
    1. Remove the 19 bolts and valve body.
      Fig 1: Identifying Bolts And Valve Body
      G04045876Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Separate the lever pin from the manual valve.
      Fig 2: Separating Lever Pin From Manual Valve
      G04045877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the check ball body and spring.
      NOTE: Do not drop the check ball body and spring.
      Fig 3: Identifying Check Ball Body And Spring
      G04045878Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals