Transmission Wire: Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE
- Using an ohmmeter, measure the resistance between the terminals.
Standard resistance
ATF TEMPERATURE SPECIFIED CONDITION CHART
| ATF Temperature |
Specified Condition |
| 20°C (68°F) |
3 to 4 kΩ |
| 110°C (230°F) |
0.22 to 0.28 kΩ |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the resistance value is not as specified, replace the transmission wire.