DTC P2716 Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT): Wiring Diagram

1. Disconnect the transmission wire connector from the transmission.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition 20°C (68°F)
   13 (SLT+) - 5 (SLT-)	5.0 to 5.6 Ω

3. Measure the resistance according to the value(s) in the table below.

Fig 2: Inspecting Transmission Wire (SLT)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG : Go to step  3

OK : Go to next Step 

1. Connect the transmission wire connector to the transmission.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition 20°C (68°F)
   E4-35 (SLT+) - E4-34 (SLT-)	5.0 to 5.6 Ω

   Fig 3: Identifying ECM E4 Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Measure the resistance according to the value(s) in the table below.

Standard resistance (Check for short) 

NG : REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK : REPLACE ECM 

1. Remove the shift solenoid valve SLT.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition 20°C (68°F)
   1 - 2	5.0 to 5.6 Ω

3. Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.

Fig 4: Checking Shift Solenoid Valve

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: 

The solenoid makes an operating sound. 

NG : REPLACE SHIFT SOLENOID VALVE SLT 

OK : REPAIR OR REPLACE TRANSMISSION WIRE