Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
The following items are common to all conditions below.
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever this DTC is not present. | P0115 - P0118 (ECT sensor) P0125 (Insufficient ECT for Closed Loop) P0500 (VSS) P0748 - P0798 (Trans solenoid (range)) |
| Turbine speed sensor circuit | Not circuit malfunction |
| Output speed sensor circuit | Not circuit malfunction |
| Shift solenoid valve S1 circuit | Not circuit malfunction |
| Shift solenoid valve S2 circuit | Not circuit malfunction |
| Shift solenoid valve S3 circuit | Not circuit malfunction |
| Shift solenoid valve S4 circuit | Not circuit malfunction |
| Shift solenoid valve SR circuit | Not circuit malfunction |
| Shift solenoid valve SL1 circuit | Not circuit malfunction |
| Shift solenoid valve SL2 circuit | Not circuit malfunction |
| ECT (Engine coolant temperature) sensor circuit | Not circuit malfunction |
| KCS sensor circuit | Not circuit malfunction |
| ETCS (Electric throttle control system) | Not system down |
| Transmission range | "D" |
| ECT | 40°C (104°F) or more |
| Spark advance from Max. retard timing by KCS control | 0°CA or more |
| Engine | Starting |
OFF malfunction (A):
TYPICAL ENABLING CONDITIONS CHART
| ECM selected gear | 5th |
| Vehicle speed | 1.2 mph (2 km/h) or more |
| Throttle valve opening angle | 6.5% or more at 2,000 rpm (Conditions vary with engine speed) |
OFF malfunction (B):
TYPICAL ENABLING CONDITIONS CHART
| ECM selected gear | 2nd |
| Vehicle speed | 1.2 mph (2 km/h) or more |
| Output speed | 2nd --> 1st down shift point or more |
| Throttle valve opening angle | 6.5% or more at 2,000 rpm (Conditions vary with engine speed) |
OFF malfunction (C):
TYPICAL ENABLING CONDITIONS CHART
| Current ECM selected gear | 6th |
| Last ECM selected gear | 5th |
| Vehicle speed (During transition from 5th to 6th gear) | Less than 62.2 mph (100 km/h) |
OFF malfunction (D):
TYPICAL ENABLING CONDITIONS CHART
| ECM selected gear | 6th |
| Engine speed-Turbine speed (NE-NT) (After transition from 5th to 6th gear) | 150 rpm or less |
| Vehicle speed | Less than 62.2 mph (100 km/h) |
ON malfunction (A):
TYPICAL ENABLING CONDITIONS CHART
| ECM selected gear | 1st |
| Vehicle speed | 1.2 mph (2 km/h) or more and less than 24.9 mph (40 km/h) |
| Engine speed-Turbine speed (NE-NT) | 150 rpm or more |
ON malfunction (B):
TYPICAL ENABLING CONDITIONS CHART
| ECM selected gear | 5th |
| Vehicle speed | 1.2 mph (2 km/h) or more |
| Throttle valve opening angle | 6.5% or more at 2,000 rpm (Conditions vary with engine speed) |