Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
TYPICAL ENABLING CONDITIONS CHART
| Monitor will run whenever these DTCs are not present | None |
| Battery voltage | 8 V or more |
| Engine RPM | 2,250 rpm or more (varies with throttle position) |
| Either of following conditions A or B is met | - |
| Condition A: | - |
| Time after PNP switch ON to OFF | 10 seconds or more |
| ECT sensor | ECT is 20°C (68°F) or more and ECT sensor does not malfunction (P0115 or P0116) |
| Condition B: | - |
| Time after PNP switch ON to OFF | 30 seconds or more |
| ECT sensor | ECT is less than 20° (68°F) or ECT sensor malfunctions (P0115 or P0116) |