LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (A760H)) >> Valve Body Assembly >> Removal

Valve Body Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN AUTOMATIC TRANSMISSION FLUID (See step 6 in  REMOVAL   ) 
  2. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See step 19 in  REMOVAL   ) 
  3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See step 3 in  REMOVAL   ) 
  4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY (See step 4 in  REMOVAL   ) 
  5. DISCONNECT TRANSMISSION WIRE (See step 5 in  REMOVAL   ) 
  6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY 
    1. Remove the 20 bolts and valve body.
      Fig 1: Removing Transmission Valve Body Assembly Bolts
      G04045272Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    2. Separate the lever pin from the manual valve.
      NOTE:
      • Do not remove the check ball and each piston.
      • Cover the valve body with a plastic bag, etc. to prevent dust or trash from entering.
      Fig 2: Separating Lever Pin From Manual Valve
      G04045273Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    3. Remove the check ball body and spring.
    NOTE: Do not drop the check ball body and spring.
    Fig 3: Removing Check Ball Body & Spring
    G04045274Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
scientia non olet · About LEMON Manuals