Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
The stop light switch remains on during GO and STOP 10 times.
GO and STOP is defined as follows;
TYPICAL ENABLING CONDITIONS TABLE
| The monitor will run whenever this DTC is not present. | None |
|---|---|
| GO: (Vehicle speed is 18.63 mph (30 km/h) or more) | Once |
| STOP: (Vehicle speed is less than 1.86 mph (3 km/h)) | Once |
| Starter | OFF |
| Battery voltage | 8 V or more |
| engine switch | ON |