Vacuum Switching Valve: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL VACUUM SWITCHING VALVE (EVAP VSV)
1. Install the vacuum switching valve (EVAP VSV) with the bolt.
  Torque: 18 N*m (182 kgf*cm, 13 ft.*lbf)
2. Connect the 2 hoses.
3. Connect the connector.
  
  Fig 1: Identifying Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )