HEATED OXYGEN SENSOR (for Sensor 2): Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HEATED OXYGEN SENSOR
1. Using SST, install the heated oxygen sensors.
  SST 09224-00010
  
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  Fig 1: Installing Heated Oxygen Sensor Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pass the heated oxygen sensor connectors through the floor panel and install the grommets.
  
  Fig 2: Identifying Grommets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT HEATED OXYGEN SENSOR CONNECTOR
1. Connect the heated oxygen sensor connector (bank 2).
  
  Fig 3: Identifying Heated Oxygen Sensor Connector (Bank 2)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the heated oxygen sensor connector (bank 1).
  
  Fig 4: Identifying Heated Oxygen Sensor Connector (Bank 1)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE BOX (See INSTALLATION )
INSTALL CONSOLE BOX REGISTER ASSEMBLY (See INSTALLATION )
INSTALL FRONT ASH RECEPTACLE SUBASSEMBLY (See INSTALLATION )
INSTALL CONSOLE PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH (See INSTALLATION )
INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY