Engine Rear Oil Seal: Installation
WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE REAR OIL SEAL
- Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
SST 09223-15030, 09950-70010 (09951-07150)
NOTE:- Wipe off extra grease of the crankshaft.
- Keep the lip free of foreign matter.
- Do not tap on the oil seal at an angle.
- Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
- INSTALL DRIVE PLATE AND RING GEAR SUBASSEMBLY (See INSTALLATION )
- INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
HINT:
See INSTALLATION .
- CHECK FOR ENGINE OIL LEAKS