LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Fuel (2GR-FSE)) >> Injector Driver >> Removal

Injector Driver: Removal

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  2. REMOVE NO. 1 INLET AIR CLEANER (See  REMOVAL  ) 
  3. REMOVE NO. 1 ENGINE COVER (See  REMOVAL  ) 
  4. REMOVE INJECTOR DRIVER 
    1. Move the lock lever in the direction indicated by the arrow to release the connector lock. Disconnect the 3 connectors with wire harness locks and the connector from the injector driver.
      Fig 1: Identifying Connector Lock
      G04056484Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt, 2 nuts and injector driver.
      Fig 2: Identifying Injector Driver Bolt And Nut
      G04056485Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: Be careful not to drop or strike the injector driver.
scientia non olet · About LEMON Manuals