Injector Driver: Installation
WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL INJECTOR DRIVER
- Install the injector driver with the bolt and 2 nuts.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:- Be careful not to drop or strike the injector driver.
- The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.
- Connect the 3 connectors with wire harness locks and the connector to the injector driver. Move the lock lever in the direction indicated by the arrow to lock the connector.
- Install the injector driver with the bolt and 2 nuts.
- INSTALL NO. 1 ENGINE COVER (See INSTALLATION )
- INSTALL NO. 1 INLET AIR CLEANER (See INSTALLATION )
- INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )