Fuel Pressure Pulsation Damper: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL PRESSURE PULSATION DAMPER
1. Install 2 new gaskets, the fuel tube and fuel pressure pulsation damper to the fuel pump.
2. Using SST, tighten the fuel pressure pulsation damper to the fuel pump.
  SST 09612-24014 (09617-24011)
  
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  HINT:
  
  The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (See REPAIR INSTRUCTION ).
  
  Fig 1: Identifying Fuel Pressure Pulsation Damper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (See INITIALIZATION ).
  HINT:
  
  Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.