LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Starting (2GR-FSE)) >> Starter Cut Relay >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT STARTER CUT RELAY 
    1. Using an ohmmeter, measure the resistance between each terminal.
      Fig 1: Measuring Resistance Between Each Terminal
      G04052769Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition
      3-5 10 MΩ or higher
      3-5 Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

      If the result is not as specified, replace the relay.

scientia non olet · About LEMON Manuals