LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Control System (2GR-FSE)) >> Accelerator Pedal >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ACCELERATOR PEDAL 
    1. Connect the intelligent tester to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the intelligent tester main switch ON.
    4. Select the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ACCEL POS #1, ACCEL POS #2.
    5. When depressing or releasing the accelerator pedal, check that the values of the accelerator POS No. 1 and accelerator POS No. 2 are within the specification.

      Accelerator POS No. 1 Standard voltage 

      VOLTAGE SPECIFICATION

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      Accelerator POS No. 2 Standard voltage 

      VOLTAGE SPECIFICATION

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 5.0 V
      Fig 1: Connecting Intelligent Tester To DLC3
      G04054954Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, check the accelerator pedal, wire harness or ECM.

scientia non olet · About LEMON Manuals