LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Brake Control) >> VEHICLE STABILITY CONTROL SYSTEM (w/ VDIM) >> DTC C0278/11 Open in ABS Solenoid Relay Circuit; DTC C0279/12 Short to B+ in ABS Solenoid Relay Circuit >> Description

DTC C0278/11 Open in ABS Solenoid Relay Circuit; DTC C0279/12 Short to B+ in ABS Solenoid Relay Circuit: Description

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

The ABS solenoid relay supplies power to the ABS solenoid and TRAC solenoid.

The solenoid relay is turned on 1.5 seconds after the engine switch is turned on (IG), and is turned off if an open or short in the solenoid is detected by self diagnosis performed when the vehicle starts running.

HINT:

If a speed signal of 4 mph (6 km/h) or more is input to the skid control ECU, with the engine switch on (IG) and the stop light switch off, the ECU performs self diagnosis of the motor and solenoid circuits.

DIAGNOSIS TROUBLE CODE CHART

DTC No. DTC Detection Condition Trouble Area
C0278/11 When any of the following (1 or 2) is detected:
  1. All of the following conditions continue for 0.2 seconds or more.
    • The IG1 terminal voltage is between 9.5 and 17.2 V.
    • The solenoid relay contact is open when the relay is ON.
    • All of the following conditions continue for 0.2 seconds or more.
  2. IG1 terminal voltage becomes lower than 9.5 V or less when the relay is turned on.
  3. The relay contact remains open.
  • ABS3 fuse
  • ABS solenoid relay
  • ABS solenoid relay circuit
  • Skid control ECU
C0279/12 Immediately after the engine switch is turned on (IG), the solenoid relay contact is closed for 0.2 seconds when the relay is turned off.
  • ABS3 fuse
  • ABS solenoid relay
  • ABS solenoid relay circuit
  • Skid control ECU