REAR PROPELLER SHAFT ASSEMBLY (for 2GR-FSE): Reassembly

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NO. 1 CENTER SUPPORT BEARING ASSEMBLY
NOTE: Be careful not to grip the propeller shaft tube too tightly in a vise as this may cause deformation.
1. Using SST, install a new No. 1 dust deflector.
  SST 09506-35010, 09316-60011 (09316-00011), 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09955-04021, 09958-04011)
  
  NOTE: Be careful not to damage the dust deflector.
  
  Fig 1: Identifying No 1 Dust Deflector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, install the No. 1 center support bearing assembly.
  SST 09950-40011 (09951-04020, 09953-04030), 09330-50010, 09950-00020, 09950-50013 (09952-05010)
  
  NOTE: Be sure to install the bearing in the correct direction.
  
  Fig 2: Identifying No 1 Center Support Bearing Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST, insert a new No. 2 dust deflector until it almost touches the rubber of the No. 1 center support bearing assembly.
  SST 09950-40011 (09951-04020, 09953-04030), 09330-50010, 09950-00020, 09950-50013 (09952-05010)
  
  NOTE: Be careful not to damage the No. 2 dust deflector.
  
  Fig 3: Identifying No 2 Dust Deflector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using a snap ring expander, install a new snap ring.
  
  Fig 4: Identifying Snap Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL PROPELLER INTERMEDIATE SHAFT
1. Install the dust boot.
  NOTE: Assemble the propeller intermediate shaft assembly after wrapping vinyl tape around the spline so that it will not damage the boot.
  
  Fig 5: Identifying Dust Boot
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply grease to the spline.
  Grease: Molybdenum disulphide lithium base NLGI No.
  
  2
3. Align the matchmarks and assemble the intermediate shaft and propeller shaft.
4. Cover the adjusting nut with the dust boot.
  NOTE: The directions of the intermediate shaft companion flange and the propeller shaft companion flange should differ by 180°.
5. Temporarily tighten the adjusting nut by hand.
  
  Fig 6: Aligning Matchmarks And Assemble Intermediate Shaft And Propeller Shaft
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002